Will an older IDE PATA hard disk be better for my Windows swap disks than my faster SATA Boot drive?
I have another drive that I will be emptying of all other content. It's an older 40 gig PATA IDE drive. Would the benefits of having a dedicated drive for the swap outweigh the disadvantages of PATA?
Also, where should I be putting Adobe scratch disks? I can't have a second dedicated drive for those, so should I put them on the boot drive, the drive with my actual files that I'm working from (PSDs, source files for Premiere, etc) or onto the new dedicated drive with the Windows swap, if I decide to use that? I know Adobe says performance is worse if it's on the same drive as Windows's swap...
Any help would be appreciated.
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$4 Answers
If it's an option, you could experiment with using a SSD (solid state drive), as this unlike a typical electromechanical hard drive has no moving parts and offers significantly faster speeds than the best hard drives out there. Don't use a USB flash drive, however, for this purpose (see http://pogue.blogs.nytimes.com/2006/06/30/30pogues-posts-3/ which talks about the limited life span of flash devices, making them unsuitable for activities such as swap file maintenance which involves rapid and frequent disk access).
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$
If you can also trying turning on PAE mode (if your hardware supports it) so that Vista can use all 4GB of your memory.
You could also try using ReadyBoost
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$
I would recommend grabbing a cheap SATAII drive to use as your swap where possible, however there is no substitute for RAM. If it's possible to use 64bit Vista, this will allow you to utilise your RAM, and maybe install more.
Having said all that, it's worth throwing that PATA drive in and just testing it out.. run some tests using your main HDD and then run the same tests using your PATA drive - say a complicated process in Photoshop. Time with a stopwatch.
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$
In that case, I'd probably keep the swap file on the SATA drive, but create a separate partition on that drive for the swap file to live on. If that isn't an option, you could create the swap file on the boot partition and use a defrag utility (e.g. Raxco PerfectDisk) to maintain it with a periodic defrag of the swap file.
To clarify, I am asking specifically about the part I mentioned in my original post. I know that ideally, each swap getting its own dedicated fast drive is the best option. I cannot buy an SSD, and cannot connect more SATA drives to this motherboard.
My options are:
1. Keep the swap on the SATA drive, that also is the Windows boot drive.
2. Put it on a dedicated drive, but one that is PATA.