Next Question
Here are a few ideas:
Ideas Nos 1:
1. Go through all of your markers. Look for the ones that don't work properly and put them into a pile. Make sure that you don't put any markers that still work into this pile, or else you will be wasting your time later on.
2. Find the appropriate caps to your markers. If you don't know where the cap is, you might as well throw the marker away because it will never work well again. However, if the cap is a different color than the marker itself, you may still put that cap onto it to keep the marker working properly.
3. Put about 1 cup of hot water into a bowl. You may also do this inside of a sink if you don't have a bowl. Put each marker into the bowl of hot water one at a time so that they become wet.
4. Find a towel when all of your markers are wet and place the markers on the towel and leave them to dry for a day. The next day, reattach the marker caps to the markers. Then, let them dry again for another day with the caps still on. When you try to use your markers again, they should continue working properly.
Idea Nos 2:
Recharge Permanent Markers
Well here are just a few ideas, depending on what type of marker your trying to revive.
Permanent markers don't run out of ink. Rather, they dry out over time. You can revive a dried-out marker with a common household ingredient.
My grandfather taught me this tip, and has used it to refill a 25 year-old marker at least 8 times - the marker is still working just fine.
A permanent marker is composed of 4 basic parts:
* The casing : The marker body. The plastic that holds the whole marker together
* The wick : A fabric tube that goes inside the casing, and sticks out on the end. The tip of the wick is what you write with.
* The cap : The plastic cap that you place over the exposed end of the wick to prevent the ink mixture from drying out.
* The ink mixture : A mixture of ink and solvent which is suspended in the wick.
When we think a permanent marker has run out of ink, what has really happened is that the solvent from the ink-solvent mixture has evaporated from the wick, and the ink no longer flows to the tip of the marker.
To wet the marker again and allow the ink to flow, inject the wick with nail polish remover using a hypodermic needle. Nail polish remover is the same type of solvent that the wick originally contained.
You may use the acetone-based nail polish remover, or the acetone-free kind which works just as well and stinks less.
You can test for ink/solvent compatibility by placing a teardrop-sized drop of solvent on the tip of your marker - if it writes after you place the drop of solvent on the tip, it is compatible.
If you're having difficulty locating a needle, visit your pharmacist and ask for one for free. Or, if you know anybody with diabetes, they will have dozens at their disposal. Only use NEW needles. Never ever, under any circumstances try this with a used needle. That would be dangerous as you could catch diseases.
Fill the needle with your chosen nail polisher remover. You will need to experiment with the exact amount since markers come in all different sizes, but don't be stingy... you will be surprised just how much you can put into a dry marker.
Insert the needle into the edge of the exposed wick and push the needle deep down (at least 1 inch down). Then, transfer the nail polish remover into the wick.
Put the cap on the marker and set it upright for a day with the wick pointing at the sky. This will allow the nail polish remover to completely saturate the wick.
Note: Set the marker in a place that is protected from staining. If the marker falls over or if there is a leak in the casing, the ink-solvent mixture can spill out and permanently stain whatever it touches.
After 1 day has passed, try your marker. If it is still too dry, add more nail polish remover. If it is to runny, leave the cap off for 1 day to let some of the solvent evaporate.
Source(s):
http://www.wikihow.com/Revive-Dried-Out--Markers
http://www.everylastpenny.com/Miscellaneous/Recharge_Permanent_Markers.html
Permalink | Report
http://toolfarm.com/2006/12/rejuvenate-dried-up-markers.html
Another process involving vinegar:
http://www.instructables.com/id/bring-a-dried-out-marker-back-to-life/
Permalink | Report
Dip each tip into the vinegar and set the marker up. The tip of the marker should be standing at the top so that the vinegar will run down inside of the fabric tip.
Wait for about 5 minutes and blot the markers on some paper until the colour starts to run, cap the markers and let them sit over night.
Source(s):
I was an elementary school teacher.
Permalink | Report
Answered Question
Best Answer Chosen by Asker
| January 12, 2009 07:07 PM |
Ideas Nos 1:
1. Go through all of your markers. Look for the ones that don't work properly and put them into a pile. Make sure that you don't put any markers that still work into this pile, or else you will be wasting your time later on.
2. Find the appropriate caps to your markers. If you don't know where the cap is, you might as well throw the marker away because it will never work well again. However, if the cap is a different color than the marker itself, you may still put that cap onto it to keep the marker working properly.
3. Put about 1 cup of hot water into a bowl. You may also do this inside of a sink if you don't have a bowl. Put each marker into the bowl of hot water one at a time so that they become wet.
4. Find a towel when all of your markers are wet and place the markers on the towel and leave them to dry for a day. The next day, reattach the marker caps to the markers. Then, let them dry again for another day with the caps still on. When you try to use your markers again, they should continue working properly.
Idea Nos 2:
Recharge Permanent Markers
Well here are just a few ideas, depending on what type of marker your trying to revive.
Permanent markers don't run out of ink. Rather, they dry out over time. You can revive a dried-out marker with a common household ingredient.
My grandfather taught me this tip, and has used it to refill a 25 year-old marker at least 8 times - the marker is still working just fine.
A permanent marker is composed of 4 basic parts:
* The casing : The marker body. The plastic that holds the whole marker together
* The wick : A fabric tube that goes inside the casing, and sticks out on the end. The tip of the wick is what you write with.
* The cap : The plastic cap that you place over the exposed end of the wick to prevent the ink mixture from drying out.
* The ink mixture : A mixture of ink and solvent which is suspended in the wick.
When we think a permanent marker has run out of ink, what has really happened is that the solvent from the ink-solvent mixture has evaporated from the wick, and the ink no longer flows to the tip of the marker.
To wet the marker again and allow the ink to flow, inject the wick with nail polish remover using a hypodermic needle. Nail polish remover is the same type of solvent that the wick originally contained.
You may use the acetone-based nail polish remover, or the acetone-free kind which works just as well and stinks less.
You can test for ink/solvent compatibility by placing a teardrop-sized drop of solvent on the tip of your marker - if it writes after you place the drop of solvent on the tip, it is compatible.
If you're having difficulty locating a needle, visit your pharmacist and ask for one for free. Or, if you know anybody with diabetes, they will have dozens at their disposal. Only use NEW needles. Never ever, under any circumstances try this with a used needle. That would be dangerous as you could catch diseases.
Fill the needle with your chosen nail polisher remover. You will need to experiment with the exact amount since markers come in all different sizes, but don't be stingy... you will be surprised just how much you can put into a dry marker.
Insert the needle into the edge of the exposed wick and push the needle deep down (at least 1 inch down). Then, transfer the nail polish remover into the wick.
Put the cap on the marker and set it upright for a day with the wick pointing at the sky. This will allow the nail polish remover to completely saturate the wick.
Note: Set the marker in a place that is protected from staining. If the marker falls over or if there is a leak in the casing, the ink-solvent mixture can spill out and permanently stain whatever it touches.
After 1 day has passed, try your marker. If it is still too dry, add more nail polish remover. If it is to runny, leave the cap off for 1 day to let some of the solvent evaporate.
Source(s):
http://www.wikihow.com/Revive-Dried-Out--Markers
http://www.everylastpenny.com/Miscellaneous/Recharge_Permanent_Markers.html
Permalink | Report
Other Answers (4)
January 12, 2009 05:05 PM
One tip I found involves attaching the markers to a string with some tape, then swinging them around for a bit, with the hope that the centrifugal force would move some of the moisture hiding out deeper within the marker to the tip: http://toolfarm.com/2006/12/rejuvenate-dried-up-markers.html
Another process involving vinegar:
http://www.instructables.com/id/bring-a-dried-out-marker-back-to-life/
Permalink | Report
January 12, 2009 07:52 PM
Poor a little vinegar into a small bowl. Dip each tip into the vinegar and set the marker up. The tip of the marker should be standing at the top so that the vinegar will run down inside of the fabric tip.
Wait for about 5 minutes and blot the markers on some paper until the colour starts to run, cap the markers and let them sit over night.
Source(s):
I was an elementary school teacher.
Permalink | Report
Answer this Question
Related Questions
If you saw a purse snatcher grab an elderly woman's purse and run down the street wou...
is there anyway I can get AT$T to upgrade my iPhone out of cycle?
Was anyone able to find the Zhu Zhu Pets Hamster Num Nums on Black Friday?
What's the difference between a Bare Drive and a Retail Drive when it comes to Intern...
is there anyway I can get AT$T to upgrade my iPhone out of cycle?
Was anyone able to find the Zhu Zhu Pets Hamster Num Nums on Black Friday?
What's the difference between a Bare Drive and a Retail Drive when it comes to Intern...
Ask a Question
Buy Mahalo Dollars with Credit Card or PayPal
Top Members
Most Popular Tags
Categories
- Anonymous
- Arts & Design
- Beauty & Style
- Books & Authors
- Business
- Cars & Transportation
- Consumer Electronics
- Coupons Deals
- Education
- Entertainment
- Environment
- Fitness
- Food & Drink
- From Email
- From Iphone
- From Twitter
- Health
- History
- Hobbies
- Home & Garden
- How Tos
- Humor
- Jobs
- Legal
- Local
- Love & Relationships
- Mahalo Answers Community
- Money
- Music
- News
- NSFW
- Parenting
- Pets
- Science & Mathematics
- Services
- Shopping
- Social Science
- Society & Culture
- Sports
- Technology & Internet
- Travel
- Video Games
Welcome New Members
- lucasrblanco, November 28, 2009 03:52 PM
- lankanpro, November 28, 2009 03:51 PM
- jeaninecurtinos..., November 28, 2009 03:51 PM
- jeanine45, November 28, 2009 03:50 PM
- seee, November 28, 2009 03:48 PM
Mahalo Dollars are the currency of Mahalo Answers.
Each Mahalo Dollar costs $1.
Once you earn more than 40 Mahalo Dollars, you can request to be paid via PayPal. Each Mahalo Dollar is currently worth $0.75 when paid out via PayPal. Learn More
