I'd like to hack an old fashioned ball-mouse to make a DIY Contour RollerMouse, any advice?
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$2 Answers
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$
If so lots of ways.
Floral arrangement foam and carve/sand to shape, then cover in fiberglass and resin. Pull out the for and your done, sans the buttons. (could even use carbon fiber for a cool look. or a kevlar/carbon mixed cloth for really cool look)
Stuff called ShapeLock ( http://shapelock.com/ ) just heat to about 150F in water and its moldable
and as a footnote, JB weld can be thinned out with acetone
You can leave an optional "tip" with Mahalo's virtual currency, Mahalo Dollars. If you are asking a difficult question that might require some research, or if you'd like a wide variety of feedback, a higher tip often leads to more answers to your question.
M$
